Exergen Network Card IRt cXMTR User Manual

Transmitter  
The t/c.XMTR is specifically designed to interface any model IRt/c by a  
simple thermocouple connector or splice. The two wire current loop can  
be used in any conventional 4-20mA, 0-5V or 0-10V circuit that is scaled  
for the temperature range of interest.  
IRt/c.XMTR  
In-Line Pre-Calibrated 4-20  
mATransmitter  
For OEMs, IRt/c sensors and t/c.XMTR can be supplied pre-wired  
together.  
· Use any existing wiring, for easy low cost installation  
· Use existing PLC, computer or controller inputs  
· In line design requires no mechanical support  
· Pre-calibrated for IRt/c type, no span or zero adjustment neces-  
sary  
· Hermetically sealed construction exceeds NEMA 4, 4X, IP65, 66,  
67  
· Stainless Steel construction can withstand harsh environments  
3.4 (86)  
.50 (12,7)  
Loop Side  
IRt/c Side  
3 ft (1 m) 26 AWG stranded  
twisted shielded pair  
thermocouple wire.  
10 ft (3 m) 22 AWG  
stranded twisted pair wire.  
t/c connector  
4 - 20 mA  
1000 Ohm  
Max  
t/c.XMTR  
Any Model IRt/c  
12 - 36 VDC  
J150  
K150  
J500  
K500  
J1200  
K1200  
K2100  
S3000  
Temperature at 4 mA  
Temperature at 20 mA  
32°F (0°C)  
150°F (65°C)  
500°F (260°C)  
1000°F (540°C)  
2000°F (1100°C)  
3000°F (1650°C)  
Accuracy  
±0.1% F.S. conversion of thermocouple mV input to mA output  
160 msec (10Hz bandwidth)  
Speed of Response  
Operating Range  
Temperature Drift  
32 to 158°F (0 to 70°C)  
<0.02% F.S. per °C  
Output Noise  
<1nv rms (100Hz bandwidth)  
Upscale: goes to >20 mA  
Input Break Indication  
Power Supply @ Load  
Storage Temperature  
12 VDC minimum @10; to 22 VDC minimum @1K  
-85 to 257°F (-65 to 125°C)  
Weight  
2.4 oz (68 g) with cables  
Housing  
Stainless steel, hermetically sealed, meets or exceeds all applicable NEMA ratings, housing  
electrically isolated from signal.  
51 Water Street, Watertown, MA 02172 USA  
800-422-3006 • 617-923-9900 • Fax 617-923-9911  
48  
C
O
R
P
O
R
A
T
I
O
N
 
Cooling Jacket Kits  
CJK-1  
for IRt/c, IRt/c.3X, IRt/c.1X  
Water/Air Cooling  
A convenient and inexpensive kit makes it possible  
to use the IRt/c with air, water, or both for service in  
harsh environments. Measuring only 1" x 4.16" (25 x  
106 mm) overall, the CJK-1 is physically small  
enough to fit into tight areas and closely monitor  
process temperatures from the optimum position - up  
close. With its all stainless steel housing, it can  
withstand the harshest environments.  
All Stainless Steel Housing  
Water Coil  
IRt/c.2  
Spring  
Water In  
Purge Air Out  
Water Out  
Extraordinarily efficient in design, the CJK requires  
only .05 gpm (190 cc/min) of water and 0.1 CFM  
(3000 cc/min) of air to protect an IRt/c at 1000°F  
(540°C).  
1/8" (3,2) Tubing  
Purge Air In  
Female Run Tee  
Reducing Union  
1/4 to 1/8  
Thermocouple Wire  
Features  
Male Connector  
Small size - 1" dia. x 4.16" lg. (25 x 106mm)  
Stainless steel housing  
Water Cooling Configuration.  
All fittings required are supplied.  
Seamless copper monotube cooling coil  
Water flow > .05 gpm (190 cc/min).  
Complete equipment for air cooling and/or  
water cooling  
Air purge included  
Super-efficient design for low air and water use  
Fits IRt/c, IRt/c.1X, IRt/c.3X  
The water  
cooling system  
consists of a  
Water cooling to 1000°F (540°C) with as little  
as 0.05 gpm (190 cc/min) and 0.1 CFM (3000  
cc/min) of air  
seamless monotube, in order  
to eliminate the possibility of  
leaking joints. For convenience, the  
seamless tubing extends 3 ft (1 m) from  
the rear of the housing.  
CJK-1  
CJK-1 Housing Dimensions  
4.16 (105,6)  
.372 (9,44)  
.44 (11,1)  
.500 (12,7)  
.75 (19,05)  
.595 (15,1)  
.22 (5,56)  
1/8 NPT  
1.00 (25,4) O.D.  
6-32 Tapped Holes -4  
10-32 Tapped Holes - 2  
51 Water Street, Watertown, MA 02172 USA  
800-422-3006 • 617-923-9900 • Fax 617-923-9911  
50  
C
O
R
P
O
R
A
T
I
O
N
 
Cooling Jacket Kits  
CJK-2  
For IRt/c.3X only  
Air Only Cooling  
Features  
Cooling up to 750°F (450°C)  
Small size - 1" dia. x 3" lg. (76 x 25.4mm)  
Stainless steel housing  
Available with brass or stainless fittings  
Air purge included  
Ultra-efficient design for low air consumption  
and maximum cooling efficiency  
Side venting for variable air flow  
51 Water Street, Watertown, MA 02172 USA  
800-422-3006 • 617-923-9900 • Fax 617-923-9911  
 
51  
C
O
R
P
O
R
A
T
I
O
N
IRt/c Accessories  
MB-1  
Multi-Purpose Mounting  
Bracket  
APK-1, APK-2  
Pumps for Purge Air  
APK-1 120VAC  
The convenient Air Pump Kit allows for fast and easy installation of  
an air source suitable for maintaining optical cleanliness of IRt/c’s in  
dirty, dusty environments. Its air flow is sufficient to keep up to five  
IRt/c.2, or one IRt/c.5 clean. Additionally, the air flow is sufficient to  
allow an IRt/c.2 to operate in ambients up to 240°F (115°C). The  
pump can be mounted on either horizontal or vertical surfaces.  
APK-2 12VDC  
Specifications:  
Air Pump - 120VAC, 120 cu.in./min (1960cc/min). Available in  
12VDC.  
Vinyl Tubing - 10 ft (3m), .25" (6mm) OD, .17" (4mm) ID.  
Standoff Mounts - allow pump to be secured vertically or  
51 Water Street, Watertown, MA 02172 USA  
800-422-3006 • 617-923-9900 • Fax 617-923-9911  
52  
C
O
R
P
O
R
A
T
I
O
N
 
IRt/c Accessories  
Connector Kit  
Thermocouple Connectors  
with Shield  
Easy Installation of IRt/c, with up to 1000'  
(300 m) Extension Cable  
Connector Ground Protects Against Electrical  
Noise Errors  
Write-On Area for Easy Identification  
to assure high accuracy. Each connector includes a  
write-on insert and an external ground strap to  
maintain the electrical connection of the ground wire  
and strengthen the mechanical connection between  
connectors.  
Superior Mechanical Connection Prevents  
Signal Loss due to Vibration or Wire Movement  
Rugged Glass-Filled Nylon Shell Rated to  
425°F (218°C)  
High Purity Thermocouple  
Alloy Pins and Sockets  
MALE  
FEMALE  
Available in J, K, E, T Types  
Ground Strap  
The new IRt/c miniature low noise  
connectors are designed to provide  
an easy connection of ground wires  
to IRt/c’s and extension wire. The  
drain wire of a 20 AWG twisted  
shield cable or the shield of the  
overbraided wire is crimped and  
held in place by the internal  
0.1 DIA.  
(2.5)  
(31.8)  
1-1/4  
1-7/16  
(36.5)  
3/16  
(4.8)  
9/32  
(7.1)  
3/32  
(2.4)  
(3.2)1/8  
(9.5)  
3/8  
(.8)  
1/32  
(16.7)  
21/32  
5/16  
(7.9)  
(3.2)  
1/8  
5/16  
(7.9)  
(7.9)  
5/16  
DIMENSIONS  
IN INCHES  
hardware. They have excellent  
thermal and electrical characteristics  
(mm)  
T/C Cable  
Twisted Shielded Pair  
Extension Cable  
Twisted Shielded Pair for High Noise Rejection  
Can Be Used Up To 1000' (300 m) Length  
FEP Teflon Jacket/Insulators -  
Service Temperature to 392°F  
(200°C)  
Type  
J
White  
Yellow  
Purple  
Blue  
K
E
T
Highest Accuracy - Thermocouple  
Grade Wire  
Available In J, K, E, T Types  
Teflon insulators  
Although commonly available thermo-  
couple extension wire may be used with  
IRt/c’s, twisted shielded pair wire is  
preferred due to its much superior noise  
rejection characteristics. This feature is  
particularly important when using IRt/c’s  
Twisted  
24 AWG Stranded Leads/  
Thermocouple Grade  
Full Foil Shield  
Teflon Outer Jacket  
Shield Drain Wire  
(-) Red  
with long extensions in electrically noisy  
environments, due to the relatively high  
impedance of IRt/c’s compared to  
ordinary thermocouples.  
51 Water Street, Watertown, MA 02172 USA  
800-422-3006 • 617-923-9900 • Fax 617-923-9911  
53  
C
O
R
P
O
R
A
T
I
O
N
 
Gooseneck Mounting Kit  
GMK-1  
For fast, convenient testing  
of IRt/cs  
For fast and convenient mounting of IRt/c’s, especially for testing, the  
Gooseneck Mounting Kit provides an inexpensive method to quickly  
install an IRt/c directly on the production line. Its heavy duty design  
provides excellent stiffness for reliable positioning. Clamps are fabricated  
of aluminum for durable performance. The sensor clamp fits all IRt/c  
models (the MB-1 Mounting Bracket is required for Adjustable IRt/c  
models),  
51 Water Street, Watertown, MA 02172 USA  
800-422-3006 • 617-923-9900 • Fax 617-923-9911  
54  
C
O
R
P
O
R
A
T
I
O
N
 

Conair Kitchen Utensil SC 5 User Manual
Craftsman Lawn Mower 24728911 User Manual
Curtis TV DVD Combo TVD2011 User Manual
Cypress Computer Hardware CY7C68000A User Manual
Desa Stove FSVYD18N User Manual
Desa Tech Fire Pit EF5802R User Manual
DigiPower Wheelchair iPT PLC User Manual
Dukane Projector 7100HC User Manual
EverFocus Security Camera EAN800A User Manual
Federal Security Camera Speaker 300GC User Manual