Dyson Vacuum Cleaner DC03 User Manual

DCO3 Operating Manual  
DYSON CUSTOMER HELPLINE  
0990 275104  
8am to 8pm, 7 DAYS A WEEK  
 
Filters and blockages  
Ensure the pre-filter is changed regularly. If filters block, the cleaner may overheat and cut out. The Dyson DC03 has a built in  
motor protection thermostat to protect the appliance in the event of a restriction to airflow. Unplug cleaner. Leave for 30 minutes.  
Fit a new pre-filter before use.  
2
4
1
3
NB If the cleaner  
is still blocked lift  
out the post-filter  
and check inside  
for dust caking.  
Pre-motor filter  
Post-motor filter  
4
1
2
Rotate twist ring to the left to release  
filter case.  
3
Lift out pre-filter using handle  
(replace at least every 12 months).  
Replace filter case and rotate twist ring  
down and to the right to secure.  
Remove filter case from machine body.  
Blockage removal  
cassette catch  
Cyclone entry  
duct  
2
4
1
3
1
2
3
4
Using a coin, undo the yellow fastener  
to remove the quick release window.  
Check for blockage at the bottom of the  
duct and underneath the soleplate.  
Remove wand from hose and look  
down the wand to check for daylight.  
Locate blockage removal cassette catch  
at base of hose location.  
Pull back catch, remove cassette and  
check for blockage. To replace, position  
at 450 and click catch back into place.  
Remove Cyclone assembly to check  
Cyclone entry and duct.  
DYSON CUSTOMER HELPLINE: 0990 275104  
8am to 8pm, 7 days a week  
 
Bin emptying and brushbar  
Do not fill bin above maximum line.  
Keep small holes  
clear of dust and fluff.  
2
5 Optional  
1
3
4
Push Cyclone release catch forward to  
free Cyclone assembly.  
Push bin release catch forward to free  
the bin.  
5
To clean bin, wash in warm water. Do  
not remove bin inner and seals, and  
ensure bin is dry before reassembling.  
1
2
3
4
Pull Cyclone assembly away from the  
machine.  
Wrap a plastic bag firmly around the  
rim of the clear bin and empty (wait  
ten seconds to allow dust to settle).  
If the brushbar is obstructed, a loud ratchet warning noise will be heard. Pull the cleaner away and it will automatically re-set itself.  
For thread removal, unplug cleaner and carefully cut away threads from brushbar.  
End cap of brushbar  
4
1
1
2
3
Raised section  
To replace brushbar, align and locate  
in slots. Rotate until the end caps click  
into place. Rotate brushbar to allow belt  
to centralise, then replace soleplate.  
If ratchet warning noise continues, stop  
vacuuming, turn off the machine and  
unplug. To free the brushbar, lie the  
2
3
Using a coin, undo the three yellow  
fasteners.  
Remove soleplate and clear the  
brushbar obstruction.  
4
machine on its front to reveal the soleplate.  
DYSON CUSTOMER HELPLINE: 0990 275104  
8am to 8pm, 7 days a week  
 
DYSON CUSTOMER CARE  
If you have any questions about your Dyson, we do not want you to be put out in any  
way. All you have to do is call the Dyson Customer Helpline on 0990 275104 from  
8am to 8pm, seven days a week.  
When calling, please have the following information ready:  
O99O 2751O4  
1. Serial number of your Dyson (between the wheels)  
2. Your postcode  
3. The date of purchase  
4. Where you made your purchase  
Most queries can be solved over the telephone. If not, this is how our repair service works:  
today  
overnight  
back to Dyson  
overnight  
back to you  
If you call before 11.00am (monday to friday), your cleaner will be collected after 12 noon that day. Our aim is to courier your  
cleaner back to the Dyson factory and return it to you repaired and tested within 48 hours. The service may take a little longer  
in some areas, such as the Highlands and Islands.  
DYSON CUSTOMER HELPLINE: 0990 275104  
8am to 8pm, 7 days a week  
 
WHEN USING THE DYSON DC03 VACUUM CLEANER  
PLEASE ADHERE TO THESE SIMPLE PRECAUTIONS  
Important safety instructions  
P L E A S E R E A D C A R E F U L L Y B E F O R E U S E  
By doing so you will reduce the risk of fire, electrical shock or injury.  
Check that your supply corresponds to that shown on the rating plate. The  
appliance must only be used as rated, and it should be fitted with an approved  
fuse to BS1362. This appliance is supplied with a moulded three pin mains plug  
for your safety and convenience. A 13 amp fuse is fitted in this plug. Should the  
fuse need to be replaced, please ensure that the replacement fuse has a rating  
of 13 amps and that it is approved by ASTA or BSI to BS1362. Check for the ASTA  
mark or the BSI mark on the body of the fuse. If the plug contains a removable  
fuse cover you must ensure that it is refitted when the fuse is replaced. If you lose  
the fuse cover, the plug must not be used until a replacement cover is obtained.  
A replacement fuse cover can be purchased from your local Dyson dealer.  
Do not leave the vacuum cleaner plugged into the mains socket outlet.  
Unplug from the outlet when not in use and before cleaning the  
appliance, and before maintenance operations.  
Ensure that hands, feet and fingers, particularly of small children are kept  
away from the cleaner and especially from the brushbar. If hanging the  
cleaner by the storage hook, ensure it is securely fixed and out of the way  
of children and pets. Never allow children to play with or use this appliance.  
Do not use without the bin assembly fitted correctly and both filters in place.  
Do not fit anything other than Dyson spare parts. This could invalidate your  
guarantee (Call the Dyson Helpline on 0990 275104).  
If the fitted moulded plug is unsuitable for the socket outlet in your home then the  
fuse should be removed and the plug cut off and disposed of safely. There is a  
danger of severe electrical shock if the cut off plug is inserted into any 13 amp  
socket.  
Do not carry out any maintenance work on the cleaner other than  
that outlined in this manual, especially where electrical components are  
concerned.  
If a new plug is to be fitted, please observe the wiring code as shown below. If in  
any doubt please consult a qualified electrician.  
Ensure that the brushbar is off when cleaning smooth floors to avoid  
marking. If carpet pilling occurs, either use the cleaner with brushbar on to  
remove, or contact the carpet retailer.  
IMPORTANT  
Static charges can occur in the clear bin when vacuuming certain carpets.  
These are entirely harmless and are not associated with the mains supply.  
To minimise any effect, do not put your hand or insert any object into the  
clear bin unless you have first emptied and rinsed out the clear bin with  
water. If wiping dust from the shroud, use a brush or a damp cloth.  
The wires in this mains lead are coloured in accordance with the following code:  
BLUE: Neutral  
BROWN: Live  
As the colours of the wire in the mains lead of this appliance may not correspond  
with the coloured markings identifying the terminals in your plug, proceed as  
follows:  
1. The wire which is coloured BLUE must be connected to the terminal in the plug  
which is marked with the letter N or coloured BLACK.  
Do not use the cleaner if the cable or plug are damaged or if the machine  
has been damaged, dropped or has come into contact with water or any  
other liquids. In these cases, contact the Dyson Helpline on 0990 275104.  
2. The wire which is coloured BROWN must be connected to the terminal in the  
plug which is marked with the letter L or coloured RED.  
Do not put any part of the body, clothes or any object near or into the  
openings or moving parts of the machine. Do not use the machine with any  
of the openings blocked with an object that may restrict the air flow.  
Under no circumstances should either of these wires be connected to the earth  
terminal of the three pin plug, marked with the letter E or the Earth Symbol  
coloured GREEN or GREEN and YELLOW.  
or  
Do not damage the cable by running the cleaner head over it, closing a door  
on it or running it over sharp edges. Do not put the cable near or on hot  
surfaces. If the cable is damaged, call the Dyson Helpline.  
Always ensure that the cable clamp is fitted and that it clamps the cable outer and  
NOT the coloured wires.  
How to replace the fuse:  
Always stand above the machine when cleaning on the stairs.  
1. Open the fuse compartment with a screwdriver.  
2. Replace the fuse and fuse cover if detachable.  
Do not, under any circumstances, use the cleaner to pick up water or any  
other liquid. Electrical shocks could occur if used outdoors or on wet surfaces.  
If the supply cable of the appliance is damaged, disconnect the appliance from the  
socket outlet immediately; the supply cable must be replaced. This should be carried  
out by Dyson Appliances Ltd only or its appointed agent, as special purpose tools  
and service techniques are required.  
Do not use the cleaner or handle the plug with wet hands.  
Do not use the machine to pick up flammable or combustible substances  
and do not use near such substances. Never pick up asbestos or asbestos  
dust or poisonous solids, such as copier toner.  
EUROPEAN CONFORMITY INFORMATION  
Do not use the machine to pick up hot ashes or burning objects of any kind.  
A sample of product has been tested  
and found to be in conformity with  
the following European Directives:  
73/23/EEC Low Voltage (Safety)  
Directive  
93/68/EEC CE Marking Directive  
Do not immerse the whole machine in water for cleaning. The clear bin  
alone may be washed out after emptying. Do not remove bin inner and  
seals. Ensure it is completely dry before re-using the cleaner.  
UNWANTED PRODUCTS AND THE ENVIRONMENT  
Do not use the cleaner near open or gas fires when they are lit.  
Turn the machine off by the switch button before unplugging from a mains  
outlet.  
Should you find one day that your product needs replacement, or is of no further  
use to you, think of the protection of the environment. Contact the Dyson Helpline  
to recycle your cleaner. The cleaners plastic parts will be sorted, cleaned, re-cleaned,  
separated, granulated, dyed and re-moulded. The re-cycled parts will then go to  
make new, Dyson Recyclone cleaners the worlds first recycled vacuum cleaner.  
When carrying the cleaner, use only the carrying handle positioned  
immediately below the on/off switch.  
 

Coleman Coffeemaker 5008 700 User Manual
Cradlepoint Cell Phone Accessories PS6PMCW User Manual
Crate Amplifiers Stereo Equalizer LS1 131 User Manual
Cuisinart Coffeemaker DCC 1100 User Manual
Curtis Stereo System RCD619 User Manual
Dixon Lawn Mower ZTR 311 User Manual
Electro Voice Musical Instrument DRP 15 User Manual
Electro Voice Portable Speaker PIM 122 User Manual
Estate Dishwasher TUD6710 User Manual
GE Air Conditioner ABN12 User Manual